Automatic High Beam — If
Equipped
This system automatically controls the opera-
tion of the headlamp high beams as oncoming
vehicles approach.
• The Automatic High Beam Headlamp Con-
trol can be turned on or off using the
Uconnect System.
• Push the turn signal lever away from you.
• With the headlight switch in the “AUTO”
position, the high beams are controlled
automatically.
• Pull the turn signal lever toward you to
manually deactivate the system.
• To improve system recognition of crossing
traffic, and to limit use in a residential area,
the vehicle must be moving at a speed
greater than 20 mph (32 km/h) before the
Automatic High Beam Module (AHBM) be-
gins requesting high beam activation.
NOTE:
If the windshield or Automatic High Beam
Headlamp Control mirror is replaced, the mirror
must be re-aimed to ensure proper perfor-
mance. See a local authorized dealer.
Engine Stop/Start — If Equipped
The STOP/START system was developed to re-
duce emissions and will turn back ON every
time the ignition is turned OFF and then back
ON again.
The system will stop the engine automatically
during a vehicle stop if the required conditions
are met.
This vehicle has been upgraded with a Heavy
Duty Battery, Starter, as well as other engine
parts, to handle the Additional engine starts.
STOP/START OFF Switch
STARTING AND OPERATING
To Next Page
Loading...
