4. Remove the rear body side tail lamp, slid-
ing it away from the back of the vehicle.
5. Replace the bulb as necessary by turning
and removing the bulb housing.
6. Insert the new bulb, making sure it is
properly locked.
7. Reposition the rear body side lamp as-
sembly on the car.
8. Reconnect the electrical connector.
9. Reinstall the body side lamp making sure
to align the ball studs.
10. Install fasteners and tighten body side
lamp assembly.
11. Finally close the tailgate.
Body Side Tail Lamp
1 — Rear Body Side Tail Lamp
2 — Ball Stud
Reverse Side of Tail Lamp
1 — Direction Indicator Bulb / Stop
Lamp Bulb
2 — Electrical Connector
3 — Ball Studs
Body Side Tail Lamp
1 — Rear Body Side Tail Lamp
2 — Ball Stud
IN CASE OF EMERGENCY
176
To Next Page
Loading...
