Do not drive your vehicle after the air bags have
deployed. If you are involved in another colli-
sion, the air bags will not be in place to protect
you.
WARNING!
Deployed air bags and seat belt pretension-
ers cannot protect you in another collision.
Have the air bags, seat belt pretensioners,
and the seat belt retractor assemblies re-
placed by an authorized dealer immediately.
Also, have the Occupant Restraint Controller
System serviced as well.
NOTE:
• Air bag covers may not be obvious in the
interior trim, but they will open during air bag
deployment.
• After any collision, the vehicle should be
taken to an authorized dealer immediately.
Enhanced Accident Response System
In the event of an impact, if the communication
network remains intact, and the power remains
intact, depending on the nature of the event, the
ORC will determine whether to have the En-
hanced Accident Response System perform the
following functions:
• Cut off fuel to the engine.
• Flash hazard lights as long as the battery has
power or until the hazard light button is
pressed. The hazard lights can be deacti-
vated by pressing the hazard light button.
• Turn on the interior lights, which remain on as
long as the battery has power or for 15
minutes from the intervention of the En-
hanced Accident Response System.
• Unlock the power door locks.
• Turn off the Gasoline Fuel Pump Heater (if
equipped) or the Diesel Fuel Filter Heater (if
equipped).
• Turn off the HVAC Blower Motor.
• Close the HVAC Circulation Door.
Enhanced Accident Response System
Reset Procedure
After the event occurs, when the system is
active, a message regarding fuel cutoff is dis-
played. Turn the ignition switch from ignition
AVV/START or MAR/ACC/ON/RUN to ignition
STOP/OFF/LOCK. Carefully check the vehicle
for fuel leaks in the engine compartment and on
the ground near the engine compartment and
fuel tank before resetting the system and start-
ing the engine.
Depending on the nature of the event the left
and right turn signal lights, located in the instru-
ment panel, may both be blinking and will con-
tinue to blink. In order to move your vehicle to
the side of the road, you must follow the system
reset procedure.
Customer Action Customer Will See
NOTE:
Each step MUST BE held for at least two
seconds
1. Turn ignition
STOP/OFF/LOCK.
(Turn Signal Must
be placed in Neutral
State).
2. Turn ignition
MAR/ACC/ON/RUN.
Right turn light
BLINKS.
Left turn light is
OFF.
3. Turn right turn
signal switch ON.
Right turn light is
ON SOLID.
Left turn light
BLINKS.
4. Place turn signal
in neutral state.
Right turn light is
OFF.
Left turn light
BLINKS.
5. Turn left turn sig-
nal switch ON.
Right turn light
BLINKS.
Left turn light is ON
SOLID.
6. Place turn signal
in neutral state.
Right turn light
BLINKS.
Left turn light is
OFF.
123
To Next Page
