EasyManua.ls Logo

Jeep COMPASS 2018 - Page 162

Jeep COMPASS 2018
712 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
HVAC is set to full defrost mode at a high
blower speed.
HVAC set to MAX A/C.
Engine has not reached normal operating
temperature.
The transmission is not in a forward gear.
Hood is open.
Vehicle is in 4WD LOW transfer case mode.
Brake pedal is not pressed with sufficient
pressure.
Other Factors Which Can Inhibit Autostop
Include:
Accelerator pedal input.
Engine temp too high.
5 MPH (8 km/h) threshold not achieved from
previous AUTOSTOP.
Steering angle beyond threshold.
Adaptive Cruise Control is on and speed is
set.
It may be possible for the vehicle to be driven
several times without the STOP/START system
going into a STOP/START READY state under
more extreme conditions of the items listed
above.
To Start The Engine While In
Autostop Mode
While in a forward gear, the engine will start
when the brake pedal is released or the throttle
pedal is depressed. The transmission will auto-
matically re-engage upon engine restart.
Conditions That Will Cause The Engine To
Start Automatically While In Autostop Mode:
The transmission selector is moved out of
DRIVE.
To maintain cabin temperature comfort.
HVAC is set to full defrost mode.
HVAC system temperature or fan speed is
manually adjusted.
Battery voltage drops too low.
Low brake vacuum (e.g. after several brake
pedal applications).
STOP/START OFF switch is pressed.
A STOP/START system error occurs.
4WD system is put into 4WD LOW mode.
Conditions That Force An Application Of The
Electric Park Brake While In Autostop Mode:
The drivers door is open and brake pedal
released.
The drivers door is open and the drivers seat
belt is unbuckled.
The engine hood has been opened.
A STOP/START system error occurs.
To Manually Turn Off The Stop/Start
System
1. Push the STOP/START Off switch (located
on the switch bank). The light on the switch
will illuminate.
2. The “STOP/START OFF” message will ap-
pear in instrument cluster display. Refer to
“Instrument Cluster Display” in “Getting To
Know Your Instrument Panel” for further in-
formation.
3. At the next vehicle stop (after turning off the
STOP/START system) the engine will not be
stopped.
STOP/START OFF Switch
159

Other manuals for Jeep COMPASS 2018

Related product manuals