WARNING ALERTS
Front Distance
(in/cm)
Greater than
47 in (120 cm)
47-39 in
(120-100 cm)
39-25 in
(100-65 cm)
25-12 in
(65-30 cm)
Less than
12 in (30 cm)
Arcs — Left None None None 2nd Flashing 1st Flashing
Arcs — Center None 4th Solid 3rd Flashing 2nd Flashing 1st Flashing
Arcs — Right None None None 2nd Flashing 1st Flashing
Audible Alert
Chime
None Audible chimes in-
crease across all four
zones as the objects
gets close to the ve-
hicle.
Audible chimes in-
crease across all four
zones as the objects
gets close to the ve-
hicle.
Audible chimes in-
crease across all four
zones as the objects
gets close to the ve-
hicle.
Continuous
Radio Volume Re-
duced
No Yes Yes Yes Yes
NOTE:
ParkSense will reduce the volume of the radio, if
on, when the system is sounding an audible
tone.
Front Park Assist Audible Alerts
ParkSense will turn off the Front Park Assist
audible alert (chime) after approximately three
seconds when an obstacle has been detected,
the vehicle is stationary, and brake pedal is
applied. If the obstacle has been detected within
less than 12 inches (30 cm), then the Parksense
will not turn off the Front Park Assist audible
alert.
Adjustable Chime Volume Settings
Front and Rear chime volume settings can be
selected from the Customer-Programmable
Features section of the Uconnect System, refer
to “Uconnect Settings” in “Multimedia” for further
information.
If the Uconnect System is equipped, chime
volume settings will not be accessible from the
instrument cluster display.
The chime volume settings include low, me-
dium, and high. The factory default volume
setting is medium.
ParkSense will retain its last known configura-
tion state through ignition cycles.
Enabling And Disabling ParkSense
ParkSense can be enabled and disabled with
the ParkSense switch, located on the switch
panel below the Uconnect display.
ParkSense Switch
180
To Next Page
Loading...
