If the tire pressure is 19 psi (1.3 Bar) or
higher:
1.
Push the Power Button to turn on Tire Service
Kit and inflate the tire
to the cold tire inflation
pressure found on the
tire and loading infor-
mation label located in
the driver-side door
opening.
NOTE:
If the tire becomes over-inflated, push the De-
flation Button to reduce the tire pressure to the
recommended inflation pressure before continu-
ing.
2. Disconnect the Tire Service Kit from the
valve stem, reinstall the cap on the valve
stem and unplug from 12 Volt outlet.
3. Place the Tire Service Kit in its proper stor-
age area in the vehicle.
4. Have the tire inspected and repaired or re-
placed at the earliest opportunity at your
authorized dealer or tire service center.
5. Remove the Speed Limit sticker from the
steering wheel after the tire has been re-
paired.
6. Replace the Sealant Bottle at your autho-
rized dealer as soon as possible. Refer to
“Sealant Bottle Replacement”.
NOTE:
When having the tire serviced, advise the au-
thorized dealer or service center that the tire has
been sealed using the Tire Service Kit.
Sealant Bottle Replacement:
1. Unwrap the power cord.
2. Unwrap the hose.
3. Remove the bottle cover.
4. Rotate the bottle up beyond vertical to re-
lease.
Unwrap The Hose
Remove The Bottle Cover
Rotate The Bottle Up
240
To Next Page
Loading...
