When the vehicle is shifted out of REVERSE with
camera delay turned off, the Surround View Camera
mode is exited and the last known screen appears
again.
When enabled, active guidelines are overlaid on the
image to illustrate the width of the vehicle, including the
side view mirrors and its projected back up path based
on the steering wheel position.
Different colored zones indicate the distance to the rear
of the vehicle.
The following table shows the approximate distances for
each zone:
Zone Distance To The Rear Of The Vehicle
Red 0 - 1 ft (0 - 30 cm)
Yellow 1 ft - 6.5 ft (30 cm - 2 m)
Green 6.5 ft or greater (2 m or greater)
Modes Of Operation
Manual activation of the Surround View Camera is
selected by pressing the Surround View Camera button
located in the Controls menu within the Uconnect
system.
Top View
The Top View will show in the Uconnect system with
Rear View and Front View in a split screen display. There
is integrated ParkSense arcs in the image at the front
and rear of the vehicle. The arcs will change color from
yellow to red corresponding the distance zones to the
oncoming object.
Surround View Camera View
NOTE:
● Front tires will be in image when the tires are turned.
● Due to wide angle cameras in the mirrors, the image
will appear distorted.
● T
op View will show which doors are open.
● Open front doors will cancel outside image.
● Open lif
tgate will cancel rear image while in Top
View.
Rear View Plus Top View
This is the default view of the system in
REVERSE and is always paired with the
Top View of the vehicle with optional active
guidelines for the projected path when
enabled.
Rear Cross Path View
Pressing the Rear Cross Path button will
give the driver a wider angle view of the
rear camera system. The Top View will be
disabled when this is selected.
Front View Plus Top View
The Front View will show you what is
immediately in front of the vehicle and is
always paired with the Top View of the
vehicle.
Front Cross Path View
Pressing the Front Cross Path button will
give the driver a wider angle view of the
front camera system. The Top View will be
disabled when this is selected.
142 STARTING AND OPERATING
To Next Page
Loading...
