Jeep Compass - Operating Modes

168 STARTING AND OPERATING
OPERATING MODES
Engine Stopping Mode
Models equipped with a manual transmission:
With the vehicle stopped, the engine stops with
the transmission in NEUTRAL and clutch pedal
released.
Models equipped with an automatic
transmission:
With the vehicle at a standstill and brake pedal
pressed, the engine switches off if the gear
selector is in a position other than REVERSE.
In the event of stops uphill, the engine switching
will be disabled to activate the "Hill Start Assist"
function (works only with the engine running).
The warning light on the instrument panel
switches on to signal that the engine was
stopped.
Engine Restarting Mode
Models equipped with manual transmission:
To restart the engine, press the clutch pedal.
If the vehicle does not start pressing the clutch,
place the gear selector in NEUTRAL and repeat
the procedure. If the problem persists, contact
an authorized dealer.
Models equipped with an automatic
transmission:
To restart the engine, release the brake pedal.
With the brake pedal pressed, if the gear
selector is in DRIVE, the engine can be restarted
moving the selector to REVERSE or NEUTRAL or
“AutoStick”.
With the brake pedal pedal pressed, if the gear
selector is in "AutoStick" mode, the engine can
be restarted moving the selector to "+" or "–", or
REVERSE or NEUTRAL.
WARNING!
Before opening the hood, make sure that the
engine is off and that the ignition is in the
OFF mode. Follow the indications on the plate
underneath the hood. We recommend that
you remove the key fob if other people remain
in the vehicle. The vehicle should only be
exited after the key fob has been removed
and the ignition is in the OFF mode. During
refueling, make sure that the engine is off
(ignition device in the OFF mode).
CAUTION!
When replacing the battery, always contact
an authorized dealer. Replace the battery
with the same type (HEAVY DUTY) and with
the same specifications.
21_M6_OM_EN_IN_t.book Page 168