174 STARTING AND OPERATING
To Resume Speed
To resume a previously set speed, push the RES
button and release. Resume can be used at any
speed above 20 mph (32 km/h).
To Deactivate
A tap on the brake pedal, or pushing the CANC
button, or normal brake pressure will deactivate
the Cruise Control system without erasing the
set speed from memory.
The following conditions will also deactivate the
Cruise Control without erasing the set speed
from memory:
Vehicle parking brake is applied
Stability event occurs
Gear selector is moved out of DRIVE
Engine overspeed occurs
Pushing the on/off button or placing the ignition
in the OFF position, will erase the set speed
from memory.
PARKSENSE REAR PARK ASSIST SYSTEM —
IF EQUIPPED
The ParkSense Rear Park Assist system
provides visual and audible indications of the
distance between the rear fascia/bumper and a
detected obstacle when backing up (e.g. during
a parking maneuver). For limitations of this
system and recommendations see,
Ú page 178.
ParkSense will retain the last system state
(enabled or disabled) from the last ignition cycle
when the ignition is changed to the ON/RUN
position.
ParkSense can be active only when the gear
selector is in REVERSE. The system will remain
active until the vehicle speed is increased to
approximately 7 mph (11 km/h) or above. While
in REVERSE and above the system's operating
speed, a warning will appear in the instrument
cluster display indicating the vehicle speed is too
fast. The system will become active again if the
vehicle speed is decreased to speeds less than
approximately 6 mph (9 km/h).
PARKSENSE SENSORS
The four ParkSense sensors, located in the rear
fascia/bumper, monitor the area behind the
vehicle that is within the sensors’ field of view.
The sensors can detect obstacles from
approximately 12 inches (30 cm) up to
79 inches (200 cm) from the rear fascia/
bumper in the horizontal direction, depending
on the location, type and orientation of the
obstacle.
PARKSENSE WARNING DISPLAY
The ParkSense Warning screen will only be
displayed if “Sound and Display” is selected
from the Customer - Programmable Features
section of the Uconnect system Ú page 200.
21_M6_OM_EN_IN_t.book Page 174
To Next Page
Loading...
