IN CASE OF EMERGENCY 295
(Continued)
(Continued)
Tool Kit Bag — If Equipped
1. Open the liftgate.
2. Lift the access cover using the load floor
handle.
3. Remove the alignment pin from the middle,
rotate the jack counterclockwise, and lift it
from the foam tray.
4. Remove the jack and wheel bolt wrench.
JACKING INSTRUCTIONS
3 — Tool Kit Bag
4 — Tow Hook
5 — Wheel Bolt Wrench
6 — Emergency Funnel
7 — Screwdriver
WARNING!
A loose tire or jack thrown forward in a
collision or hard stop could endanger the
occupants of the vehicle. Always stow the jack
parts and the spare tire in the places
provided. Have the deflated (flat) tire repaired
or replaced immediately.
WARNING!
Carefully follow these tire changing warnings
to help prevent personal injury or damage to
your vehicle:
Always park on a firm, level surface as far
from the edge of the roadway as possible
before raising the vehicle.
Turn on the Hazard Warning Flashers.
Block the wheel diagonally opposite the
wheel to be raised.
Apply the parking brake firmly and set the
transmission in PARK.
Never start or run the engine with the
vehicle on a jack.
Do not let anyone sit in the vehicle when it
is on a jack.
Do not get under the vehicle when it is on a
jack. If you need to get under a raised
vehicle, take it to a service center where it
can be raised on a lift.
WARNING! (Continued)
21_M6_OM_EN_IN_t.book Page 295
To Next Page
Loading...
