Jeep Compass - Turn Signals; Lane Change Assist - if Equipped; Headlight Leveling System - if Equipped

52 GETTING TO KNOW YOUR VEHICLE
To activate the rear fog lights, push the lower
half of the headlight switch. To turn off the rear
fog lights, push the lower half of the headlight
switch a second time.
NOTE:
To turn on the rear fog lights, the low beam
headlights or front fog lights must first be active.
If the vehicle is only equipped with rear fog
lights, only a single button will be available in
the center of the headlight switch. Push once to
turn the rear fog lights on, and a second time to
turn them off.
An indicator light in the instrument cluster
illuminates when the fog lights are turned on.
TURN SIGNALS
Move the multifunction lever up or down to
activate the turn signals. The arrows on each
side of the instrument cluster display flash to
show proper operation.
NOTE:
 If either light remains on and does not flash,
or there is a very fast flash rate, check for a
defective outside light bulb.
 A “Turn Signal On” message will appear in the
instrument cluster display and a continuous
chime will sound if the vehicle is driven more
than 1 mile (1.6 km) with either turn signal
on.
LANE CHANGE ASSIST — IF EQUIPPED
Push the multifunction lever up or down,
without moving beyond the detent, and the turn
signal will flash three times then automatically
turn off.
HEADLIGHT LEVELING SYSTEM — IF
E
QUIPPED
This system allows the driver to maintain proper
headlight beam position with the road surface
regardless of vehicle load.
The control switch is located on the instrument
panel next to the dimmer control.
Headlight Leveling Control
21_M6_OM_EN_IN_t.book Page 52