Jeep Compass - Page 211

Component Fluid, Lubricant, or Genuine Part
Spark Plugs – 2.0L and 2.4L Engine We recommend you use MOPAR Spark Plugs.
Fuel Selection We recommend you use minimum 91 Research Octane Number (RON), 0–15% Ethanol.
Chassis
Component Fluid, Lubricant, or Genuine Part
Automatic Transmission (CVT) – If Equipped Use only MOPAR CVTF+4 Continuously Variable Transmission Fluid or equivalent. Failure to use
the correct fluid may affect the function or performance of your transmission.
Automatic Transmission (6-Speed) – If
Equipped
Use only MOPAR SP-IV M Automatic Transmission Fluid or equivalent. Failure to use the correct
fluid may affect the function or performance of your transmission.
Manual Transmission – If Equipped We recommend you use MOPAR Manual Transmission Lubricant meeting the requirements of
FCA Material Standard MS-9602 or FCA Material Standard 9.55550-AV4.
Rear Drive Assembly (RDA) We recommend you use MOPAR Gear & Axle Lubricants SAE 80W-90 API GL-5 meeting the re-
quirements of FCA Material Standard MS-9020.
Power Transfer Unit (PTU) We recommend you use MOPAR Gear & Axle Lubricants SAE 80W-90 API GL-5 meeting the re-
quirements of FCA Material Standard MS-9020.
Brake Master Cylinder We recommend you use MOPAR Brake & Clutch Fluid DOT 4, that meets the requirements of
FCA Material Standard MS.90039.
DOT 4 brake fluid must be changed every 24 months. This interval is time based only, mileage
intervals do not apply.
Power Steering Reservoir We recommend you use MOPAR Power Steering Fluid +4, or MOPAR ATF+4 Automatic Transmis-
sion Fluid or equivalent licensed ATF+4 product.
208