Automatic Unlock Doors On Exit
The doors will unlock automatically if:
• The Automatic Unlock Doors On Exit feature
is enabled.
• The transmission was in gear, and the vehicle
speed returned to 0 MPH (0 km/h).
• The transmission is in NEUTRAL or PARK.
• The driver’s door is opened.
• The doors were not previously unlocked.
Automatic Unlock Doors On Exit
Programming
The Automatic Unlock Doors On Exit feature
can be enabled or disabled as follows:
• For vehicles equipped with the instrument
cluster display, refer to “Instrument Cluster
Display — If Equipped/Personal Settings
(Customer-Programmable Features)” in “Get-
ting To Know Your Instrument Panel” for
further information.
• For vehicles not equipped with the instrument
cluster display, perform the following proce-
dure:
1. Close all doors and place the key in the
ignition.
2. Within 15 seconds, place the ignition be-
tween LOCK and ON/RUN and then back to
LOCK five times, ending up in the ON/RUN
position (do not start the engine).
3. Within 30 seconds, push the power door
unlock switch to unlock the doors.
4. A single chime will indicate the completion of
the programming.
5. Repeat these steps if you want to return this
feature to its previous setting.
NOTE:
• If you do not hear the chime, it means that
the system did not enter the programming
mode and you will need to repeat the
procedure.
• Use the Automatic Unlock Doors On Exit
feature in accordance with local laws.
Child-Protection Door Lock System
— Rear Doors
To provide a safer environment for small chil-
dren riding in the rear seats, the rear doors are
equipped with Child-Protection Door Lock sys-
tem.
To Engage Or Disengage The Child-
Protection Door Lock System
1. Open the rear door.
2. Insert the tip of the ignition key into the lock
and rotate to the lock or unlock position.
3. Repeat steps 1 and 2 for the opposite rear
door.
Child-Protection Door Lock Location
Child-Protection Door Lock Function
26
To Next Page
Loading...
