Jeep Gladiator 2020 - Oil Life Reset - if Equipped

GETTING TO KNOW YOUR INSTRUMENT PANEL 169
The Main Menu items consists of the following:
• Speedometer
• Veh
icle Info
• Off
Road — If Equipped
• Dri
ver Assist — If Equipped
• Fuel
Economy
• Tri
p Info
• Sto
p/Start — If Equipped
• Aud
io
• Mes
sages
• Scr
een Setup
Oil Life Reset — If Equipped
Your vehicle may be equipped with an engine oil change
indicator system. The “Oil Change Required” message will
display in the instrument cluster display for five seconds
after a single chime has sounded to indicate the next sched
-
uled oil change interval. The engine oil change indicator
s
yste
m is duty cycle based, which means the engine oil
change interval may fluctuate, dependent upon your
personal driving style.
Unless reset, this message will continue to display each time
you p
lace the ignition in the ON/RUN position. To turn off
the message temporarily, push and release the OK button.
To reset the oil change indicator system (after performing the
scheduled maintenance), refer to the following procedure.
Oil Life Reset
1. Without pushing the brake pedal, place the ignition in the
ON/R
UN mode (do not start the engine).
2. Navigate to "Oil Life" submenu in "Vehicle Info" in the
ins
trument cluster display.
3. Push and hold the OK b
utton until the gauge resets to
100%.
Secondary Method For Oil Change Reset Procedure
1. Without pushing the brake pedal, place the ignition in the
ON/R
UN position (do not start the engine).
2. Fully press the accelerator pedal, slowly, three times
with
in ten seconds.
3. Without pushing the brake pedal, place the ignition in the
OFF/LO
CK position.
3