Non-Locking Storage Wall
The Non-Locking Storage Wall can be used for storage
by folding the bottom of the rear seat up and placing
items behind the wall.
There is also an option to remove the wall by removing
the four bolts that connect the storage wall to the floor.
Locking Storage Bin
If equipped, the Locking Storage Bin is located below
the rear seats. It can be accessed by folding the rear
seat bottom upward into the Stadium Position.
The Locking Storage Bin has two keyed locks on the
front of the bin and uses the same key as the glove
compartment and the center console for your vehicle.
Inside the bin are three removable dividers to set up
storage that works best for you.
The Locking Storage Bin can be removed by unfasten-
ing the four bolts that attach the bin to the vehicle floor
using the provided #40 Torx head driver and ratchet.
The bottom of the storage bin has rubber mats that
need to be removed to access the four bolts. These
bolts can then be stored in the fastener bin below the
rear seat.
Your Locking Storage Bin also has a front handle that
makes it easier to carry and pull out from the floor of
the vehicle when the four bolts that attach the bin to
the floor are removed.
Rear Behind Seat Storage — If Equipped
The rear wall storage bin is located behind the right
rear seat.
Rear Wall Storage Bin
To access the storage bin, pull upward on the pull strap
located on the upper outboard side of the right rear
seat, and fold the seatback forward.
NOTE:
The rear seatback can be locked using the vehicle key
to secure items in the rear wall storage bin. The seat
lock is located on the upper outboard side of each seat-
back. Both seatbacks should be locked to limit access
to items behind seat.
Non-Locking Storage Wall
Locking Storage Bin (Closed View)
Under Seat Storage (Open View)
1 — Key Locks
2 — Removable Bolts
3 — Handle
Rear Wall Storage Bin
1 — Rear Wall Storage Bin
2 — Pull Strap
60 GETTING TO KNOW YOUR VEHICLE
To Next Page
Loading...
