32
If, during assembly and commissioning, you should encounter factory defects, unclear steps or find
it difficult to assemble some parts, do not ride the electrically power assisted cycle and contact your
authorised dealer’s Service Centre or visit the website www.jeepurbanemobility.com/en/support/ for
support.
Before using the bike, it must be correctly assembled and checked in all its parts. Any damage due
to incorrect assembly, adjustments or maintenance is not covered by the guarantee. For further
information, technical support, assistance or to consult the general terms of the warranty, contact
your authorised dealer or visit the website www.jeepurbanemobility.com/en/support/
In the event of fall
Any falls can undergo the bike and its components to high stresses, therefore, before resuming
pedalling, it is necessary to check that there is no damage related to the incident; see:
• check that the frame and the fork have no breaks, folds and/or cracks
• check that the handlebars and the handlebar stem are not deformed or broken
• check that the rims are still centred in the frame and fork by spinning the wheel
• check that the tyres are intact
• check the correct functioning of the gear change and the derailleur with all the reduction ratios
without coming into contact with the spokes and that the chain does not fall outside its housing;
• check that the saddle is stable
Signs of damage or failure after a collision or a fall may be not visible on certain components. It
is recommended to consult a specialized operator to have an adequate inspection of the product
before proceeding with the subsequent use of the same.
CAUTION
CAUTION
Do not resume usage of the bike in the presence of even the slightest doubt that something may
have been damaged.
DANGER
To Next Page
