WHITE INDICATOR LIGHTS
Adaptive Cruise Control (ACC) Ready
Indicator Light — If Equipped
This light will turn on when ACC has been
turned on, but is not set
page 124.
Cruise Control Ready Indicator Light
This indicator light will illuminate when the
cruise control is ready, but not set
page 122.
Hill Descent Control (HDC) Indicator
Light — If Equipped
This indicator shows when the HDC feature
is turned on. The light will be on solid when
HDC is armed. HDC can only be armed when
the transfer case is in the 4WD Low position
and the vehicle speed is less then 30 mph (48 km/h). If
these conditions are not met while attempting to use
the HDC feature, the HDC indicator light will flash
on/off.
Intelligent Speed Assist (ISA) Ready
Indicator Light — If Equipped
The ISA system combines the Active Speed
Limiter and Traffic Sign Assist (TSA) systems
to automatically adjust the maximum speed
of the vehicle based on detected traffic
signs. The message “Ready” will appear along with a
white indicator light in the instrument cluster display to
signal that the system has been activated.
Active Lane Management Indicator Light
— If Equipped
When the Active Lane Management system
is ON, but not armed, the Active Lane Man-
agement indicator light illuminates solid
white. This occurs when only left, right, or
neither lane line has been detected. If a single lane line
is detected, the system is ready to provide only visual
warnings if an unintentional lane departure occurs on
the detected lane line
page 144.
Rear Seat Unoccupied Indicator Light —
If Equipped
This light indicates when the rear passenger
seats are unoccupied, and will illuminate in
the upper right portion of the instrument
cluster display, momentarily replacing the
configurable corner information.
Selec-Speed Control Indicator Light —
If Equipped
This light will turn on when Selec-Speed Con-
trol is activated.
To activate Selec-Speed Control, ensure the
vehicle is 4WD Low and push the button on
the Instrument Panel.
NOTE:
If the vehicle is not in 4WD Low, “To Enter Selec-Speed
Shift to 4WD Low” will appear in the instrument cluster
display.
BLUE INDICATOR LIGHTS
High Beam Indicator Light
This indicator light will illuminate to indicate
that the high beam headlights are on. With
the low beams activated, push the multifunc-
tion lever forward (toward the front of the
vehicle) to turn on the high beams. Pull the multifunc-
tion lever rearward (toward the rear of the vehicle) to
turn off the high beams. If the high beams are off, pull
the lever toward you for a temporary high beam on,
“flash to pass” scenario.
GRAY INDICATOR LIGHTS
Night Vision Suppressed Indicator Light
— If Equipped
This light alerts the driver that the Night
Vision Warning System status is Suppressed
page 148.
ONBOARD DIAGNOSTIC SYSTEM — OBD II
Your vehicle is equipped with a sophisticated Onboard
Diagnostic system called OBD II. This system monitors
the performance of the emissions, engine, and trans-
mission control systems. When these systems are oper-
ating properly, your vehicle will provide excellent perfor-
mance and fuel economy, as well as engine emissions
well within current government regulations.
If any of these systems require service, the OBD II sys-
tem will turn on the Malfunction Indicator Light (MIL). It
will also store diagnostic codes and other information
104 GETTING TO KNOW YOUR INSTRUMENT PANEL
To Next Page
Loading...
