•
Engine has not reached normal operating
temperature.
•
The transmission is not in a forward gear.
•
Hood is open.
•
Vehicleisin4WDLOW.
•
Brake pedal is not pressed with sufficient pressure.
•
Accelerator pedal input.
•
Engine temperature is too high.
•
5 mph (8 km/h) threshold has not been achieved
from previous Autostop.
•
Steering angle is beyond threshold.
•
A Stop/Start system error occurs.
•
Stop/Start OFF switch is pushed.
•
Vehicle is in high altitude.
It may be possible for the vehicle to be driven several
times without the Stop/Start system going into a STOP/
START READY state under more extreme conditions of
the items previously listed.
TO START THE ENGINE WHILE IN
AUTOSTOP MODE
While in a forward gear, the engine will start when the
brake pedal is released or the throttle pedal is pressed.
The transmission will automatically re-engage upon
engine restart.
Conditions That Will Cause The Engine To Start Auto-
matically While In Autostop Mode:
•
The transmission selector is moved out of DRIVE.
•
To maintain cabin temperature comfort.
•
HVAC is set to full defrost mode.
•
HVAC system temperature or fan speed is manually
adjusted.
•
Battery voltage drops too low.
•
Stop/Start OFF switch is pushed.
•
A Stop/Start system error occurs.
•
4WD system is put into 4WD LOW or N (Neutral).
•
Steering angle is beyond threshold.
TO MANUALLY TURN OFF THE
STOP/START SYSTEM
Push the Stop/Start OFF switch (located on the switch
bank). The light on the switch will illuminate. The
“STOP/START OFF” message will appear in the instru-
ment cluster display and the Autostop mode will be dis-
abled
page 88.
NOTE:
The Stop/Start system will reset itself back to the ON
mode every time the ignition is turned OFF and back
ON.
TO MANUALLY TURN ON THE
STOP/START SYSTEM
Push the Stop/Start OFF switch (located on the switch
bank). The light on the switch will turn off.
SYSTEM MALFUNCTION
If there is a malfunction in the Stop/Start system, the
system will not shut down the engine. A "SERVICE
STOP/START SYSTEM" message and a yellow Stop/Start
telltale will appear in the instrument cluster display
page 88.
If the “SERVICE STOP/START SYSTEM” message
appears in the instrument cluster display, have the sys-
tem checked by an authorized dealer.
CRUISE CONTROL SYSTEMS —
IF EQUIPPED
Your vehicle may be equipped with the Cruise Control
system, or the Adaptive Cruise Control (ACC) system:
•
Cruise Control will keep your vehicle at a constant
preset speed.
•
Adaptive Cruise Control (ACC) will adjust the vehicle
speed up to the preset speed to maintain a distance
with the vehicle ahead.
NOTE:
In vehicles equipped with ACC, if ACC is not enabled,
Fixed Speed Cruise Control will not detect vehicles
directly ahead of you. Only one Cruise Control feature
can operate at a time.
Stop/Start OFF Switch
122 STARTING AND OPERATING
To Next Page
Loading...
