Jeep Wagoneer 2024 - Towing Requirements - Trailer Lights and Wiring

NOTE:
•
An aftermarket controller may be available for use
with trailers with air or EOH trailer brake systems. To
determine the type of brakes on your trailer and the
availability of controllers, check with your trailer
manufacturer or dealer.
•
Removal of the ITBM will cause errors and it may
cause damage to the electrical system and elec-
tronic modules of the vehicle. See an authorized
dealer if an aftermarket module is to be installed.
Towing Requirements — Trailer Lights
And Wiring
Whenever pulling a trailer, regardless of the trailer size,
stop lights and turn signals on the trailer are required
for motoring safety.
The Trailer Tow Package may include a wiring harness.
Use a factory approved trailer harness and connector.
NOTE:
Do not cut or splice wiring into the vehicle’s wiring
harness.
The electrical connections are all complete to the
vehicle but you must mate the harness to a trailer con-
nector. Refer to the following illustrations.
NOTE:
•
Disconnect the trailer wiring connector from the
vehicle (or any other device plugged into the vehi-
cle's electrical connectors) before launching a boat
into water.
•
Be sure to reconnect once clear from water area.
Seven-Pin Connector
1 — Backup Lamps
2 — Running Lamps
3 — Left Stop/Turn
4 — Ground
5 — Battery
6 — Right Stop/Turn
7 — Electric Brakes
13–Pin Connector — If Equipped
STARTING AND OPERATING 161
4