6. Slide the retainer up the steel extension tube and
winch cable. Rotate the retainer and push it through
the hole in the wheel.
JACKING INSTRUCTIONS
WARNING!
Carefully follow these tire changing warnings to help
prevent personal injury or damage to your vehicle:
•
Always park on a firm, level surface as far from the
edge of the roadway as possible before raising the
vehicle.
•
Turn on the Hazard Warning Flashers.
•
Apply the parking brake firmly and set the trans-
mission in PARK.
•
Block the wheel diagonally opposite the wheel to
be raised.
•
Never start or run the engine with the vehicle on a
jack.
•
Do not let anyone sit in the vehicle when it is on a
jack.
(Continued)
WARNING!
•
Do not get under the vehicle when it is on a jack. If
you need to get under a raised vehicle, take it to a
service center where it can be raised on a lift.
•
Only use the jack in the positions indicated and for
lifting this vehicle during a tire change.
•
If working on or near a roadway, be extremely care-
ful of motor traffic.
•
To assure that spare tires, flat or inflated, are
securely stowed, spares must be stowed with the
back of the wheel facing the ground.
•
The jack should be used on level firm ground wher-
ever possible.
•
It is recommended that the wheels of the vehicle
be chocked, and that no person should be remain
in a vehicle that is being jacked.
•
No person should place any portion of their body
under a vehicle that is supported by a jack.
1. Loosen (but do not remove) the wheel lug nuts,
using the lug wrench by turning them counterclock-
wise, one turn, while the wheel is still on the ground.
2. Assemble the jack and tools
page 259.
NOTE:
Placement for the front and rear jacking locations
are critical. Keep the jack and tools aligned while
raising the vehicle to prevent tool damage. See the
following images for proper jacking locations.
Releasing Winch Retainer
Jack Warning Label
Loosen Lug Nuts
Jack And Tool Assembled
260 IN CASE OF EMERGENCY
To Next Page
Loading...
