3. Press memory button (1) or (2) for two or more sec-
onds. The instrument cluster display will indicate
which memory position has been set.
NOTE:
Memory profiles can be set without the vehicle in PARK,
but the vehicle must be below 5 mph (8 km/h) to recall
a memory profile.
LINKING AND UNLINKING THE KEY
FOB TO MEMORY
Your key fobs can be programmed to recall one of two
saved driver’s side memory profiles.
NOTE:
Before programming your key fobs you must select the
“Personal Settings Linked To Key Fob” feature through
the Uconnect Settings
page 170.
To program your key fobs, perform the following:
Wagoneer
1. Place the vehicle’s ignition in the OFF position.
2. Select a desired driver’s side memory profile, 1 or 2.
3. Once the profile has been recalled, push and
release the set (S) button on the memory switch.
4. Within five seconds, push and release button (1) or
(2) accordingly. “Memory Profile Set” (1 or 2) will
display in the instrument cluster.
5. Push and release the lock button on the key fob
within 10 seconds.
NOTE:
Your key fobs can be unlinked from your driver’s side
memory settings by pushing the set (S) button, and
within 10 seconds, pushing the unlock button on the
key fob.
Grand Wagoneer
1. Place the vehicle’s ignition in the OFF position.
2. Recall the desired memory profile (1 or 2).
3. Press the memory button (1) or (2) (according to the
previous selection) for two seconds or more, and
release.
4. Push and hold the lock button on the key fob within
10 seconds.
NOTE:
Your key fobs can be unlinked from your driver’s side
memory settings by pushing the memory button (1) or
(2) for two seconds or more and releasing, and then
within 10 seconds, pushing and holding the unlock but-
ton on the key fob.
MEMORY POSITION RECALL
NOTE:
Memory Recall is available when not in PARK, if the
vehicle speed is below 5 mph (8 km/h).
•
To recall a memory settings using the memory
switches, push memory button (1) or (2) on the
memory switch.
•
To recall the driver’s side memory settings using the
key fob, push the unlock button on the key fob
linked to memory position 1 or 2.
A recall can be canceled by pushing any of the memory
buttons during a recall, or by pushing any of the seat
adjustment switches. When a recall is canceled, the
seat and power tilt/telescopic steering column will stop
moving. A delay of one second will occur before another
recall can be selected.
SEATS
Seats are a part of the Occupant Restraint system of
the vehicle.
WARNING!
•
It is dangerous to ride in a cargo area, inside or
outside of a vehicle. In a collision, people riding in
these areas are more likely to be seriously injured
or killed.
•
Do not allow people to ride in any area of your
vehicle that is not equipped with seats and seat
belts. In a collision, people riding in these areas
are more likely to be seriously injured or killed.
•
Be sure everyone in your vehicle is in a seat and
using a seat belt properly.
MANUAL ADJUSTMENT FRONT
SEATS — IF EQUIPPED
WARNING!
•
Adjusting a seat while the vehicle is moving is dan-
gerous. The sudden movement of the seat could
cause you to lose control. The seat belt might not
be adjusted properly and you could be injured.
Adjust the seat only while the vehicle is parked.
(Continued)
GETTING TO KNOW YOUR VEHICLE 31
2
To Next Page
Loading...
