Push upward on the driver’s or passenger’s
side toggle switch on the faceplate, or press
and slide the temperature bar towards the
red arrow button on the touchscreen for
warmer temperature settings. Push downward the driv-
er’s or passenger’s side toggle switch on the faceplate,
or press and slide the temperature bar towards the blue
arrow button on the touchscreen for cooler temperature
settings.
SYNC Button
Press the SYNC button on the touchscreen
to turn the SYNC feature on/off. The SYNC
indicator illuminates when SYNC is on. SYNC
is used to synchronize the front passenger
temperature and rear passenger temperature, mode,
and blower settings with the driver temperature, mode,
and blower settings. Changing the front passenger tem-
perature or rear passenger temperature, mode, and
blower settings while in SYNC will automatically exit this
feature.
NOTE:
•
When SYNC is not active, the rear passenger climate
control settings will need to be adjusted manually to
achieve desired comfort. See
page 61 and
page 62 for more information.
•
The SYNC setting is only available on the
touchscreen.
Blower Control
Blower Control is used to regulate the
amount of air forced through the Climate
Control system. There are several blower
speeds available. The speeds can be
selected using the blower control buttons on the
touchscreen.
Use the small blower icon to reduce the blower setting
and the large blower icon to increase the blower set-
ting. Blower speed can also be selected by pressing the
numbered blower speed on the bar area between the
blower icons.
NOTE:
You can also adjust the blower speed by pushing the
single blower control toggle switch on the faceplate.
Push the toggle switch downward to decrease speed, or
upward to increase speed.
Tri-Mode Climate
Three airflow distribution modes can be selected on/off
individually by pressing the icons on the touchscreen
for up to seven combinations of airflow. The icons on
the screen will illuminate when selected, and turn off
when deselected.
The three airflow modes are:
Windshield (Front Defrost outlets)
Face (instrument panel outlets)
Feet (floor outlets)
Mode Control Button On The Instrument Panel
The airflow distribution mode can also be
selected by pushing the hard toggle switch
on the instrument panel, below the radio
screen. Pushing this toggle switch down will
cycle through the seven mode combinations in order:
Face, Face/Feet, Feet, Windshield/Feet, Windshield,
Windshield/Face, and Windshield/Face/Feet. The cycle
will repeat if the button is continually pushed.
Blower Control Toggle Switch
60 GETTING TO KNOW YOUR VEHICLE
To Next Page
Loading...
