AUTOMATIC TEMPERATURE
CONTROL (ATC)
Automatic Operation
1. Push the AUTO button on the front climate control
display, and the word “AUTO” will illuminate along
with two temperatures for the driver and front pas-
senger. The system will then automatically regulate
the amount of airflow.
2. Adjust the temperature you would like the system to
maintain, by adjusting the driver, passenger, and
rear temperatures. Once the desired temperature is
displayed, the system will achieve, and automati-
cally maintain, that comfort level.
3. When the system is set up for your comfort level, it
is not necessary to change the settings. You will
experience the greatest efficiency by simply allowing
the system to function automatically.
NOTE:
It is not necessary to move the temperature settings.
The system automatically adjusts the temperature,
mode, and fan speed to provide comfort as quickly as
possible.
To provide you with maximum comfort in the automatic
mode during cold start-ups, the blower fan will remain
on low until the engine warms up. The fan will engage
immediately if the Defrost mode is selected, or by
changing the front blower setting.
Manual Operation Override
This system offers a full complement of manual over-
ride features. The AUTO symbol in the front climate con-
trol display will no longer be illuminated when the sys-
tem is being used in the manual mode.
NOTE:
The system will not automatically sense the presence of
fog, mist or ice on the windshield. Defrost mode must
be manually selected to clear the windshield and side
glass.
CLIMATE VOICE RECOGNITION
Adjust vehicle temperatures hands-free and keep every-
one comfortable while you keep moving ahead (If
vehicle is equipped with climate control).
Push the VR/Phone button
. After the beep, say
one of the following commands:
•
“ Set the driver temperature to 20 degrees”
•
“ Set the passenger temperature to 20 degrees”
Did You Know: Voice Command for Climate may only be
used to adjust the interior temperature of your vehicle.
Voice Command will not work to adjust the heated
seats or steering wheel if equipped.
OPERATING TIPS
CAUTION!
Interior air enters the Rear Climate Control system
through an intake grille, located in the right side trim
panel behind the third row seats. The heater outlets
are located in the right side trim panel, just behind
the rear doors. Do not block or place objects directly
in front of the inlet grille or heater outlets. The electri-
cal system could overload causing damage to the
blower motor.
Refer to the chart at the end of this section for sug-
gested control settings for various weather conditions.
Summer Operation
The engine cooling system must be protected with a
high-quality antifreeze coolant to provide proper corro-
sion protection and to protect against engine overheat-
ing. OAT coolant (conforming to MS.90032) is
recommended.
Winter Operation
To ensure the best possible heater and defroster perfor-
mance, make sure the engine cooling system is func-
tioning properly and the proper amount, type, and con-
centration of coolant is used. Use of the Air
Recirculation mode during Winter months is not recom-
mended, because it may cause window fogging.
Vacation/Storage
For information on maintaining the Climate Control sys-
tem when the vehicle is being stored for an extended
period of time, see
page 310.
Window Fogging
Vehicle windows tend to fog on the inside in mild, rainy,
and/or humid weather. To clear the windows, select
Defrost or Mix mode and increase the front blower
speed. Do not use the Recirculation mode without A/C
for long periods, as fogging may occur.
Outside Air Intake
Make sure the air intake, located directly in front of the
windshield, is free of obstructions, such as leaves.
Leaves collected in the air intake may reduce airflow,
and if they enter the air distribution box, they could plug
the water drains. In Winter months, make sure the air
intake is clear of ice, slush, and snow.
64 GETTING TO KNOW YOUR VEHICLE
To Next Page
Loading...
