NOTE:
If all doors are programmed to unlock on first press
within Uconnect Settings
page 170, all doors will
unlock when you push the electronic liftgate release. If
only the driver’s door is programmed, only the liftgate
will unlock when you push the electronic liftgate
release.
NOTE:
•
Use the power door lock switch on either front door
trim panel or the key fob to lock and unlock the
liftgate.
•
The driver's door lock cylinder will not lock and
unlock the liftgate.
•
The vehicle must be in PARK to utilize the liftgate
open/close button.
WARNING!
Driving with the liftgate open can allow poisonous
exhaust gases into your vehicle. You and your passen-
gers could be injured by these fumes. Keep the lift-
gate closed when you are operating the vehicle.
NOTE:
The liftgate can also be opened manually by pushing
the electronic liftgate release handle and pulling
upward in one fluid motion.
TO LOCK/CLOSE THE LIFTGATE
There are several different ways to close the liftgate:
•
Manually (grab the liftgate closing handle and pull
downward)
•
Key fob
•
Hands-free (if equipped)
•
Liftgate close button in the cargo area
With a valid Passive Entry key fob within 5 ft (1.5 m) of
the liftgate, pushing the Passive Entry button, located
to the left of the electronic liftgate release handle, will
lock the vehicle only.
If the liftgate is fully open, the liftgate can be closed by
pushing the liftgate close button located in the cargo
area on the left rear trim panel, near the liftgate open-
ing. If the liftgate is in motion, pushing the liftgate close
button a second time will reverse the liftgate operation.
ADJUSTABLE POWER LIFTGATE
HEIGHT
The maximum height that the liftgate will open can be
adjusted and saved so that the liftgate will only open to
the desired height. To set a desired height, proceed as
follows:
1. Open the liftgate fully, then manually pull down on
the liftgate to the desired height.
2. Push and hold the liftgate close button, located on
the left side trim panel inside the cargo area, for
three seconds. An audible chime will be heard to let
you know the height has been saved.
To reset the saved height setting to a new setting, pro-
ceed as follows:
1. Open the liftgate, then manually push the liftgate
upward to its full open position.
2. Manually pull the liftgate down to the new desired
height and hold the liftgate close button for three
seconds until the audible chime is heard.
Liftgate Entry
1 — Passive Entry Lock Button
2 — Electronic Liftgate Release Handle
Liftgate Close Button
GETTING TO KNOW YOUR VEHICLE 77
2
To Next Page
Loading...
