NOTE:
The crossbars should only be used in positions 1 and
2 or positions 1 and 3. They are not designed to be
used in positions 2 and 3.
NOTE:
There are arrows on top of the crossbars that indicate
the direction that they should be installed. The arrows
should point forward toward the front of the vehicle.
To install the crossbars, refer to the following
procedure:
1. Remove the crossbars from the foam blocks.
2. Swivel the outboard stanchion on the crossbar and
rotate it 180 degrees around the bolt to the open
position. Open the outboard stanchion on the oppo-
site end of the crossbar as well.
Crossbar Locations
1 — Position 1
2 — Position 2
3 — Position 3
Crossbar and Tie Down Loop Locations
1 — Crossbar Installation Location
2 — Tie-Down Loop Locations
Crossbar Directional Arrow
Step 2
Open Outboard Stanchion (Underside Shown)
GETTING TO KNOW YOUR VEHICLE 81
2
To Next Page
Loading...
