INSTRUMENT CLUSTER
DESCRIPTIONS
1. Speedometer
○
Indicates vehicle speed.
NOTE:
A chime will sound when the vehicle speed is above
120 km/h.
2. Temperature Gauge
○
The temperature gauge shows engine coolant
temperature. Any reading within the normal
range indicates that the engine cooling system
is operating satisfactorily.
○
The pointer will likely indicate a higher tempera-
ture when driving in hot weather, up mountain
grades, or when towing a trailer. It should not be
allowed to exceed the upper limits of the normal
operating range.
WARNING!
A hot engine cooling system is dangerous. You or oth-
ers could be badly burned by steam or boiling cool-
ant. It is recommended to call an authorized dealer
for service if your vehicle overheats.
CAUTION!
Driving with a hot engine cooling system could dam-
age your vehicle. If the temperature gauge reads “H”
pull over and stop the vehicle. Idle the vehicle with
the air conditioner turned off until the pointer drops
back into the normal range. If the pointer remains on
the “H”, turn the engine off immediately and call an
authorized dealer for service.
3. Tachometer
○
Indicates the engine speed in revolutions per
minute (RPM x 1000).
4. Fuel Gauge
○
The pointer shows the level of fuel in the fuel
tank when the Keyless Push Button Ignition is in
the ON/RUN position.
○
The fuel pump symbol points to the
side of the vehicle where the fuel
door is located.
NOTE:
The Instrument Cluster Warning Indicators will illumi-
nate briefly for a bulb check when the ignition is first
cycled.
86 GETTING TO KNOW YOUR INSTRUMENT PANEL
To Next Page
Loading...
