EasyManua.ls Logo

Jeep Wagoneer 2024 - Battery Saver On;Battery Saver Mode Message - Electrical Load Reduction Actions (if Equipped)

Jeep Wagoneer 2024
728 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
When Advanced” mode is selected, the HUD
displays the vehicle speed, turn-by-turn naviga-
tion, speed limit, driver assist function(s), and
current gear.
Custom 1: Speed, Speed Limit
Custom 2: Speed, Speed Limit, Navigation
Custom 3: Speed, Speed Limit, Navigation, Driver
Assist (ACC/Cruise, Active Lane Management,
Active Driving Assist)
Custom 4: Speed, Speed Limit, Navigation, Driver
Assist (ACC/Cruise, Active Lane Management,
Active Driving Assist), Gear (only available in
Sport mode)
Display Height
Brightness
NOTE:
The HUD basic settings (Brightness, Display Height
and Non Custom layouts), are controlled through the
Settings Screen in the Instrument Cluster
page 88.
If current theme is set to Digital, tachometer will not
display while in the Settings menu.
BATTERY SAVER ON/BATTERY
SAVER MODE MESSAGE
ELECTRICAL LOAD REDUCTION
ACTIONS (IF EQUIPPED)
This vehicle is equipped with an Intelligent Battery Sen-
sor (IBS) to perform additional monitoring of the electri-
cal system and status of the vehicle battery.
In cases when the IBS detects charging system failure,
or the vehicle battery conditions are deteriorating, elec-
trical load reduction actions will take place to extend
the driving time and distance of the vehicle. This is
done by reducing power to or turning off non-essential
electrical loads.
Load reduction is only active when the engine is run-
ning. It will display a message if there is a risk of battery
depletion to the point where the vehicle may stall due
to lack of electrical supply, or will not restart after the
current drive cycle.
When load reduction is activated, the message “Battery
Saver On” or “Battery Saver Mode” will appear in the
instrument cluster.
These messages indicate the vehicle battery has a low
state of charge and continues to lose electrical charge
at a rate that the charging system cannot sustain.
NOTE:
The charging system is independent from load
reduction. The charging system performs a diagnos-
tic on the charging system continuously.
If the Battery Charge Warning Light is on it may indi-
cate a problem with the charging system
page 97.
The following are electrical loads that may be switched
off (if equipped), and vehicle functions which can be
affected by load reduction:
Heated Seat/Vented Seats/Heated Wheel
Rear Defroster And Heated Mirrors
HVAC System
230 Volt AC Power Inverter System
Audio and Telematics System
Loss of the battery charge may indicate one or more of
the following conditions:
The charging system cannot deliver enough electri-
cal power to the vehicle system because the electri-
cal loads are larger than the capability of the charg-
ing system. The charging system is still functioning
properly.
Turning on all possible vehicle electrical loads (e.g.
HVAC to max settings, exterior and interior lights,
overloaded power outlets +12 Volt, 230 Volt AC,
USB ports) during certain driving conditions (city
driving, towing, frequent stopping, etc.).
Installing options like additional lights, upfitter elec-
trical accessories, audio systems, alarms and simi-
lar devices.
Unusual driving cycles (short trips separated by long
parking periods).
The vehicle was parked for an extended period of
time (weeks, months).
The battery was recently replaced and was not
charged completely.
The battery was discharged by an electrical load left
on when the vehicle was parked.
Advanced Mode
GETTING TO KNOW YOUR INSTRUMENT PANEL 95
3

Table of Contents

Related product manuals