GETTING TO KNOW YOUR VEHICLE 35
To raise the center head restraint, lift up on the
head restraint. To lower the center head restraint,
push the adjustment button, located at the base of
the head restraint, and push down on the head
restraint.
Center Head Restraint
NOTE:
Lower the center head restraint to avoid contact
with the seat bottom cushion when folding the seat
down.
To remove the center head restraint, push the
release button and the adjustment button at the
same time while pulling upward on the head
restraint.
To reinstall the head restraint, put the head
restraint posts into the holes and push downward.
Then, adjust the head restraint to the appropriate
height. Refer to “Occupant Restraint Systems” in
“Safety” in the Owner’s Manual for information on
child seat tether routing.
HOOD
OPENING
Release both of the outside hood latches.
Hood Latch Locations
WARNING!
Sitting in a seat with the head restraint in its
lowered position could result in serious injury or
death in a collision. Always make sure the
outboard head restraints are in their upright
positions when the seat is to be occupied.
1 — Release Button
2 — Adjustment Button
WARNING!
A loose head restraint thrown forward in a
collision or hard stop could cause serious
injury or death to occupants of the vehicle.
Always securely stow removed head restraints
in a location outside the occupant compart-
ment.
ALL the head restraints MUST be reinstalled in
the vehicle to properly protect the occupants.
Follow the preceding reinstallation instruc-
tions prior to operating the vehicle or occu-
pying a seat.
WARNING!
Always place the ignition in the OFF position
before opening the hood. If the ignition is in the
RUN position and the Propulsion System is
active when the hood is opened, the engine
could automatically start, and persons not clear
of the vehicle could be injured by the engine’s
moving parts.
2
23_JL_H_SU_EN_USC_t.book Page 35
To Next Page
Loading...
