Screen Setup
Push and release the up or down arrow button
until the Screen Setup Menu Icon/Title is highlighted in
the instrument cluster display. Push and release the OK
button to enter the submenus and follow the prompts
on the screen as needed. The Screen Setup feature
allows you to change what information is displayed in
the instrument cluster as well as the location that infor-
mation is displayed.
NOTE:
Based upon equipment options and current vehicle
status, some of the features may not be available.
Screen Setup Driver Selectable Items
Upper Left and Right
None Current Econ
(MPG,
L/100km,
or km/L)
Average Econ
(MPG,
L/100km,
or km/L)
Outside Temp Compass Trip A Distance
Range To Empty Time Trip B Distance
Center
None Compass Time
Outside Temp Average Econ
(MPG,
L/100km,
or km/L)
Trip A Distance
Range to Empty Audio Speedometer
Center
Current Econ
(MPG,
L/100km,
or km/L)
Trip B Distance Menu Title
Favorite Menus
Speedometer Stop/Start Vehicle Info
Off Road –
If Equipped
(show/hide)
Messages Driver Assist – If
Equipped
(show/hide)
Fuel Economy
(show/hide)
Screen Setup Trip Info
(Show/Hide)
Audio
(show/hide)
Gear Display — If Equipped
•
Full
•
Single
Current Gear — If Equipped
•
On
•
Off
Odometer — If Equipped
•
Show
•
Hide
Defaults (Restores All Settings To Default Settings)
•
Cancel
•
Restore
The menu with (show/hide) means user can press OK
button to choose show or hide this menu on the instru-
ment cluster display.
Phone Call Status — If Equipped
A pop-up message for an incoming call will appear on
any screen within your instrument cluster. The pop-up
message will appear on your screen until it is cleared
out of the call is ignored, answered, or the calling ends.
NOTE:
The Uconnect Settings can be programmed to turn the
pop-up off. This will not affect the audio menu or any
phone status information
page 177.
Any incoming calls, active calls, and outgoing calls will
take the place of your audio information.
A caller’s name will only be displayed if:
•
A number is associated with the call. The phone
number will be displayed in place of the caller’s
name.
•
The test/font of the name is not supported by the
instrument cluster. The instrument cluster will not
display anything in place of the name.
•
The caller’s name exceeds the maximum number of
characters. The last two to three digits that will fit
will be replaced with “...”.
NOTE:
Any audio information will return to the instrument clus-
ter once the call has ended.
BATTERY SAVER ON/BATTERY
SAVER MODE MESSAGE —
ELECTRICAL LOAD REDUCTION
ACTIONS — IF EQUIPPED
This vehicle is equipped with an Intelligent Battery Sen-
sor (IBS) to perform additional monitoring of the electri-
cal system and status of the vehicle battery.
110 GETTING TO KNOW YOUR INSTRUMENT PANEL
To Next Page
Loading...
