2. Remove the hardware storage cover by pinching the
latch on the left side and pulling upward.
3. Turn the plastic wing nut counterclockwise to loosen
the jack from the storage bin.
4. Remove tool kit and assemble tools.
SPARE TIRE REMOVAL
1. To remove the spare tire from the carrier, remove
the tire cover, if equipped.
2. Remove the Rear Camera Cover by turning the lock
bolt counterclockwise with the #T40 torx head driver
and ratchet from the supplied tool kit.
3. Remove the lug nuts with the lug wrench turning
them counterclockwise. If equipped, remove the
locking lug nut with the lock key (located in the glove
box) turning it counterclockwise.
JACKING INSTRUCTIONS
WARNING!
Carefully follow these tire changing warnings to help
prevent personal injury or damage to your vehicle:
•
Always park on a firm, level surface as far from the
edge of the roadway as possible before raising the
vehicle.
•
Turn on the Hazard Warning Flashers.
•
Apply the parking brake firmly and shift an auto-
matic transmission into PARK; a manual transmis-
sion into REVERSE.
•
Block the wheel diagonally opposite the wheel to
be raised.
•
Never start or run the engine with the vehicle on a
jack.
•
Do not let anyone sit in the vehicle when it is on a
jack.
(Continued)
Hardware Storage Cover Latch
Plastic Wing Nut Location
Unlock Rear Camera Cover
Removing The Spare Tire
284 IN CASE OF EMERGENCY
To Next Page
Loading...
