5. Insert the hinge shoulder bolt through the bottom of
the upper door hinge up into the mirror bracket,
then rotate the bracket knob toward the rear of the
vehicle to secure the mirror bracket to the A-pillar.
6.
Tighten both the bracket bolt and the hinge shoulder
bolt with a #40 Torx head driver. Recommended torque
specification for the bracket bolt is 6 ft-lb (8 N·m), and
7.5 ft-lb (10 N·m) for the hinge shoulder bolt.
7. Lower the mirror assembly onto the mirror bracket.
8. Insert the three mirror screws into the mirror assem-
bly, and tighten into the mirror bracket using a
#30 Torx head driver. Recommended torque specifi-
cation for the mirror screws is 4 ft-lb (5.5 N·m).
9. Repeat the steps on the other side of the vehicle.
NOTE:
If this kit is being installed with the optional lamp
bracket, the bracket bushing from step 4 is not needed.
Use the spacer from the lamp bracket.
HALF-DOOR INSTALLATION —
IF EQUIPPED
If applicable, refer to the “Hybrid Supplement” for addi-
tional information.
CAUTION!
•
Do not run half-doors through an automatic car
wash. This may result in scratches and wax
buildup on the windows.
•
Careless handling and storage of the half-doors
may damage the seals resulting in water leaks into
the interior of the vehicle.
•
The upper half-doors must be positioned properly
to ensure sealing. Improper installation can cause
water leaks into the interior of the vehicle.
•
Store the zipper pulls of the upper half-door win-
dows at the upper B-pillar area for both front and
rear doors to avoid damage to the windows when
not in use.
•
Do not attempt to operate the half-door zipper in
temperatures of 41°F (5°C) or below. Damage to
the window may occur.
Attaching Mirror Bracket To The Vehicle
1 — Bracket Bushing
2 — Bracket Bolt
Attaching Mirror Bracket To The Vehicle
1 — Bracket Knob
2 — Hinge Shoulder Bolt
Lower Mirror Assembly Onto Bracket
Mirror Screw Locations
GETTING TO KNOW YOUR VEHICLE 31
2
To Next Page
Loading...
