NOTE:
To prevent water leaks, the seals and hard top panels
should be clear of any dust and debris prior to
reinstallation.
REMOVING THE HARD TOP
1. Remove both front panels page 81.
2. Open both front doors.
3. Using the provided #50 Torx head driver and
ratchet, remove the two Torx head screws that
secure the hard top at the B-pillar (near the top of
the front doors).
4. Remove the six Torx head screws that secure the
hard top to the vehicle (along the interior bodyside —
three screws on each side) using the #50 Torx head
driver.
5. Open the swing gate all the way to ensure clearance
of the rear window glass. Lift the rear window glass.
6. Locate the wire harness and washer hose on the left
rear inside corner of the vehicle.
7. Release the locking tab by pushing it downward.
Step Three
Step Four
Step Five
Step Six
Step Seven
GETTING TO KNOW YOUR VEHICLE 85
2
To Next Page
Loading...
