3. From the front of the Sunrider® top, lift and push
the top rearward to the Sunrider® position.
4. Secure the top by using the two hook-and-loop fas-
teners provided with the Sunrider® kit, and wrap
one around the side rails on each side of the
Sunrider® top to hold it in place.
POWER SLIDING TOP —
IF EQUIPPED
CAUTION!
Lowering of the windshield is NOT recommended in
vehicles equipped with a Power Sliding Top. Damage
will occur to the top as well as the header seal.
If your vehicle is equipped with a Power Sliding Top, the
control switch can be found on the front trim panel, to
the right of the driver’s side sun visor.
NOTE:
•
The power top is non-removable. If desired, the rear
quarter windows can be removed and stored in the
provided storage bag
page 91.
•
The power top will not open in temperatures below
-4°F (-20°C). However, if it is opened at a higher
temperature, it can be closed at temperatures
above -40°F (-40°C).
•
The power top will not operate at vehicle speeds
above 60 mph (96 km/h).
NOTE:
A slight pause in audio may be heard when opening
and closing the Power Sliding Top as a result of the
Uconnect system switching between power top Closed
and power top Open audio modes.
Release Both Header Latches
Sunrider® Position
Hook-And-Loop Fastener Placement Power Sliding Top Control Switch
1 — Open Switch
2 — Close Switch
GETTING TO KNOW YOUR VEHICLE 89
2
To Next Page
Loading...
