Intended use
LDM52 OEM, Release 003, Revision 000
3 Intended use
3.1 Operating and storage conditions
15% … 60%, non-condensing
The LDM52 OEM has to be used in a closed housing only.
3.2 Improper use and possible error sources
The unit may be used only as prescribed.
Please do not remove any labels and type plates.
Repair work must not be performed by the user. In case of questions or doubt, the man-
ufacturer is to be consulted. For contact data see section 2.5.
In order to obtain correct measuring values the following advice is to be observed:
1. Measurements against the sun or onto surfaces with low reflectivity in very
bright environments can result in faulty measurements.
2. Measurements through glass, optical filters, Plexiglas or other translucent materi-
als are possible to a limited extent but can result in measurement errors.
To Next Page
Loading...
Need help?
General