Parameter setup and measuring operation
LDM52 OEM, Release 003, Revision 000
6.4.10 PR – Parameter setting
Resetting of all parameters to factory settings (default values)
The following parameters are not reset by entering PR:
BR Baud rate
RS Serial port
SB Stop bits
Setting parameters for serial interface
Output:
Parameters set to firmware defaults.
Baudrate of serial port [BR]: 115200
Stopbits of serial port [SB]: 1
Average [SA]: 1
Measurement frequency [MF]: 0.0
Minimum distance from target [MW]: -5000000
Maximum distance from target [MW]: 5000000
Offset in 'mm / 10' [OF]: 0
Parametrization of switching output Q1 [Q1]: 0, 1000000, 2500, 0
Parametrization of switching output Q2 [Q2]: 0, 1000000, 2500, 0
Parametrization of switching output Q3 [Q3]: 0, 1000000, 2500, 0
Parametrization of the analog switching output QA [QA]: 0, 1000000
Unit for the distances [MUN]: mm
Trigger (input) [TRI]: 0, 0
Trigger (output) [TRO]: 0, 0
Autostart commands [AS]: DT
Output format [SD]: 0 0 0 0
Terminator [TE]: 0x0D0A
Scale factor [SF]: 0.000
Error mode [SE]: 0
Separator [SP]: 0x2C
Heating on threshold [HE]: 4
Heating off threshold [HE]: 10
Standard tracking mode from menu [MCT]: 0
To Next Page
Loading...
Need help?
General