Parts List
üNAV102 navigation module
üAntenna with magnetic mount
üFour rubber feet (to affix to the bottom of the NAV102 in the
recessed area near each corner)
üSmartBus cable (used to connect the NAV102 to the Jensen
navigation-ready radio)
üOne 2 Gigabyte SD Card pre loaded with map/navigation
software
üTwo 11mm (.4in) screws (for fastening the SmartBus cable
to the radio and NAV102)
üDVD with backup software for map data and navigation
Warnings
Do not install components in areas which are susceptible to
rain, moisture, direct sunlight, extreme heat or cold,
excessive dust, dirt or humidity.
Do not install the NAV102 where it will obstruct the driver’s
view or interfere with the vehicle’s operating system or
safety features (air bags, hazard light buttons, etc.).
Use only installation parts and hardware provided with the
unit. Use of other parts can cause malfunction and possible
damage to your navigation system.
This product should only be installed in vehicles with a 12-
volt battery with negative grounding. Check the battery
voltage of your vehicle before installation.
Be sure to secure all wires/cables safely away from the
steering wheel, shift lever, and gas or brake pedal.
Do not cut the GPS antenna cable to shorten or lengthen it.
NAV102 Placement
The NAV102 should be installed under the back or front seat. It
can also be installed in the trunk, if necessary. Do not install the
NAV102 where it will come in contact with water or direct
sunlight.
To avoid shorts in the electrical system, be sure to
disconnect the negative (–) battery cable before beginning
installation.
NOTE:
Be sure to install
the NAV102 in such
a way that the
SD card slot is
accessible after
install, allowing
for the removal
and insertion of
the SD card for
future changes
to map data or
upgrades.
NAV102 Installation Guide
VM9212N
VM9213
VM9223
VM9312HD
VM9313
VM9412
VM9413
VM9423
VM9512
VM9512HD
VM9022
VM9022HD
Compatible Head Units
AMM10N
AMM12N
SERIES
UV9
To Next Page
Need help?
General
