Miter Gauge
A full-featured miter gauge is
included
The JET Deluxe XACTA Saw comes with a full-featured miter
gauge. Its 17 3/4”-long bar follows the miter slot smoothly and
accurately. A disc at the bars leading end engages the T-shaped
miter slots and prevents the miter gauge from lifting during a
cut.
The miter gauge fence turns to 60-degrees (left or right) and
locks easily at any point, including the adjustable presets at 90
and 45-degrees with a twist of the handle.
Accessories
Dado Insert (#708097)
An all-metal dado insert is available for the JET Deluxe
XACTA Saw. It features leveling screws and an opening
sized to accept stacked dado sets at up to 13/16” widths.
Tenoning Jig (#708295)
Cutting tenons on a table saw is efficient, especially when
there are many to make. Our cast iron Tenoning Jig makes
cutting tenons accurate, consistent and very safe. The
heavy cast iron base and miter slot follower keeps the
Tenoning Jig stable and tracking straight for smooth
precise cuts.
Our accessory Dado Throat Insert
is designed to work with most
stacked dado sets at their full
13/16”-widths.
The JET Tenoning Jig is made
primarily of cast iron to be very
sturdy and stable for safety and
accuracy. The Tenoning Jig is fully
adjustable and makes repeating
these cuts safe, feast and accurate.
The Tenoning Jig is fully adjustable and capable of
making angle tenons up to 45-degrees to the side or and
front-to-back for maximum versatility. An easy to use
screw-type clamp keeps the stock firmly secured for safety
and accuracy.
To Next Page
Loading...
Need help?
General
