~ be turned 90 degrees,the tool rest extensionadded
, to the tool rest, and the tool rest moved out to the
bed extension (Fig. 14).
For face plate turning, the tool rest is set
approximately 1/8" from the work piece and slightly
lower than centerline. The chisel must be held on
the left half of the tool rest so that the rotation of the
work piece keeps the chisel against the tool rest.
Attempts at cutting from the right side of the rest may
cause the chisel to be ripped from the operator's
hand.
~
J
",--
~~
~ ~"' - .---.-
--- --
11
FIG-14
--
-- -- --- '--'--
To Next Page
Loading...
