Sliding the monitor back in
After the monitor reaches its limit,
check the alignment and then re-
install all monitor connection on both
the upper and lower displays. BE
CAREFUL WHEN INSTALLING THE
CONNECTORS AS THE PINS CAN BEND
VERY EASY. MAKE SURE THE PINS ARE
ALIGNED BEFORE PUSHING BACK
INTO THE MONITOR.
CHANGING MOTORS ON THE EEL OR PELICAN BONUS
Inspecting or replacing the assembly
Visually check the assembly for linkage
problems and or replace the motor.
When re-installing a new motor,
ensure the linkage is installed
correctly so that the claw will rest in
the down position when the motor is
turned off. After replacing the motor,
re-install the assembly back into the
cabinet and re-attach the acrylic
structure. You may also want to lightly
clean the playfield while you have
access at this point.
Sliding the monitor back in
CAREFULLY slide the monitor back into
position. Again, do not pull on the
glass itself. Only pull / push on the
metal frame and or the glass holder.
Jennison Entertainment Technologies Ocean Pearls Service Manual Page 113
To Previous Page
Loading...