Jet Ocean Pearls - Page 21

Connect the second 8 Pin connector to the connector board.
CAUTION
Check Box When This Step is Complete
Step # 3-K
Connect the 5 Pin Molex to the connector board. These wires control
the vertical and horizontal cascading LED lights on the front left and
right of the main cabinet and the lower horizontal LED lights along the
bottom of the control center and main cabinet.
INSTALLATION INSTRUCTIONS
AS YOU MATE THE CONNECTION, BE SURE THAT NO
PINS GET PUSHED OUT.
AS YOU MATE THE CONNECTION, BE SURE THAT NO
PINS GET PUSHED OUT.
CAUTION
AS YOU MATE THE CONNECTION, BE SURE THAT NO
PINS GET PUSHED OUT.
Step # 3-I
Connect the 4 Pin connector.
CAUTION
Check Box When This Step is Complete
Step # 3-J
Check Box When This Step is Complete
Jennison Entertainment Technologies Ocean Pearls Service Manual Page 21