Locate the cabinet mounting brackets (In the spare parts box (OR)
alrerady installed onto the control center) and install the the bolts on
the left side of the control center. Do not tighten all the way until the
other side is lined up properly. When BOTH SIDES are properly
aligned, careful tighten all the bolts.
DO NOT TRY AND MOVE THE ENTIRE UNIT BY
PUSHING OR PULLING ON THE CONTROL CENTER.
ONLY MOVE THE ENTIRE UNIT BY PUSHING ON THE
MAIN CABINET.
After the control center is attached to the main cabinet - do not try
and move the unit by pushing or pulling on the control center. It is
better to push or pull on the sides of the main cabinet and the the
control center come with the main cabinet.
Locate both Section # 3 and Section # 4 boxes and remove them from
the skid.
Check Box When This Step is Complete
Check Box When This Step is Complete
Locating the control center components box
Check Box When This Step is Complete
INSTALLATION INSTRUCTIONS
Jennison Entertainment Technologies Ocean Pearls Service Manual Page 24
To Next Page
Loading...