Jet Ocean Pearls - Page 35

Locate middle holding area or bridge. Begin to install at the angle
shown in the photo to the right.
Step # 7
Check Box When This Step is Complete
Step # 7-B
Lift up on the right side of the assembly and guide the opening into
the two securing bolts located on elevator # 2.
Check Box When This Step is Complete
Slide the assembly in at a 45 degree angle to the securing bolts on
elevator # 1.
Check Box When This Step is Complete
Step # 7-A
INSTALLATION INSTRUCTIONS
Jennison Entertainment Technologies Ocean Pearls Service Manual Page 35