LOOSE PINS WILL CAUSE PROBLEMS ON STARTUP
DO NOT FORCE THE MOLEX CONNECTORS TOGETHER
IF YOU CANT GET THEM TO ALIGN. DOING SO COULD
PUSH OUT OR BEND THE PINS.
Connect the 12 Pin Molex connector. The wires on this connection
control the claw motor, claw direction, left limit sensor, right limit
sensor, claw solenoid
Check Box When This Step is Complete
Check Box When This Step is Complete
Ensure that when you connect the 12 Pin connectors, you check the
top connector and make sure all pins are secure and none have
pushed out.
Check Box When This Step is Complete
INSTALLATION INSTRUCTIONS
Jennison Entertainment Technologies Ocean Pearls Service Manual Page 41
To Next Page
Loading...