Jet Ocean Pearls - Page 48

After pulling the wires out of the back of the marquee, push the wires
into the access hole in the top of Section # 4.
Check Box When This Step is Complete
INSTALLATION INSTRUCTIONS
Step # 13-L
After the marqee is aligned properly and the rear screws installed -
tighten the two front screws.
Check Box When This Step is Complete
Step # 13-M
Locate the 12 volt wire harness and feed it through the hole in the
bottom left rear of the marquee.
Check Box When This Step is Complete
Step # 13-N
Jennison Entertainment Technologies Ocean Pearls Service Manual Page 48