What to do if Jet PT-1636J Trucks lowers by itself after lifting?
If your Jet Trucks lowers by itself after being lifted, it could be due to several reasons: * The steel ball might not be seated correctly in the hydraulic unit. * There could be oil leakage from Release Plug #36. Tighten Release Plug #36 and replace the O-rings on it. If the leakage continues, further assistance might be needed.
Why my Jet PT-1636J Trucks hydraulic unit does not lift?
If the hydraulic unit of your Jet Trucks isn't lifting, it might be due to the following: * The oil level in the tank could be low. Check for any oil leakage from Release Plug #36, and add oil if needed. * There might be air in the pump. To resolve this, place the lever in the down position and pump the handle repeatedly.
What to do if Jet PT-1636J Trucks fork does not lower?
If the fork on your Jet Trucks isn't lowering, it could be due to a broken Cam #53. In this case, replace Cam #53.
To Next Page
General