&, WARNING
.
Read and understand the entire
.
Replacewarning labels if they become
instruction manual before operating
obscured or removed.
machine.
.
Make certain the motor switch is in the OFF
.
This manual is intended to familiarize
position before connecting the machine to
you with the technical aspects of this the power supply.
bandsaw. It is not, nor was it intended
to be, a training manual.
.
Giveyourworkundividedaftention.
Lookingaround,carryingona
.
This machine is designed and intended
conversation, and "horse-play" are careless
for use by properly trained and
acts that can result in serious injury.
experienced personnel only. If you are
not familiar with the proper safe use of a
.
Keepvisitors a safe distance from the work
bandsaw, do not use this machine until
area.
proper training and knowledge has been
obtained.
.
Use recommendedaccessories; improper
accessories may be hazardous.
.
Always wear approved safety glasses/face
shields while using this machine.
.
Make a habit of checking to see that keys
andadjustingwrenchesareremoved
.
Make certain the machine is properly
before turning on the machine.
grounded.
.
Never attempt any operation or adjustment
.
Before operating the machine, remove tie, if the procedure is not understood.
rings, watches, other jewelry, and roll up
sleeves above the elbows. Remove all
.
Keepfingers away from the bladewhile in
loose clothing and confine long hair. Do operation.
not wear gloves.
.
Keep belt guard in place and in working
.
Keep the floor around the machine clean
order.
and free of scrap material, oil and grease.
.
Never force the cutting action.
.
Keep machine guards in place at all times
whenthemachineis inuse. If removedfor
.
Do not attempt to adjust or remove tools
maintenance purposes, use extreme during operation.
caution and replace the guards
immediately.
.
Always keep the blade sharp.
.
Do not over reach. Maintaina balanced
.
Always use identicalreplacement parts
stance at all times so that you do not fall or
when servicing.
lean against blades or other moving parts.
.
Read and understandall warnings posted
.
Make all machine adjustmentsor
on the machine.
maintenance with the machine unplugged
from the power source.
.
Failureto comply with all of these warnings
may cause serious injury.
.
Use the right tool. Don't force a tool or
attachment to do ajob which it was not
designed for.
To Next Page
Loading...
