Jet VBS-1408 - Page 6

Electrical Connections
The VBS-1408 bandsaw is rated at 115/230Vand
comes from the factory prewired 115V.
The VBS-1610 bandsaw is rated at 230/460Vand
comes from the factory prewired230V.
To switch to from 115Vto 230V (or 230Vto 460V)
operation, follow the wiring diagram found on the
inside cover of the motorjunction box.
The bandsaw must be grounded. A qualified
electrician can make the proper electrical
connections and confirm the power on site is
compatible with the saw.
Before hooking up to the power source, makesure
the switch is in the off position.
Controls
t
~
.
B
!
~
. "-C
~/J
Note: Pictures used for illustrationsshow the VBS-
1610. The descriptions and functions are the same
for the VBS-1408, exceptwhere noted.
Variable Speed Hand Wheel (A, Fig. 2) - located
below work table on right side of machine base.
Turn clockwise to increase speed and counter-
clockwise to decrease speed. Caution: Do not turn
handlewhile machine is stopped. Adjust speed only
when machine is running.
Upper Blade Guide Lock Knob (B, Fig. 2) - located
on right side of upper arm. Turn counter-clockwise
to loosen and clockwiseto tighten.
A
Work Lamp Switch (C, Fig. 2) - on top of lamp
shade; turns lamp on and off.
Main Motor Start Switch (0, Fig. 2) - located on
upper front column. Depress to start bandsaw.
Main Motor Stop Switch (E, Fig. 2) - located on
upper front column. Depress to stop bandsaw.
Figure 2