Esteam
®
Features and Directions.
ESTEAM
®
Directions for Use
1. Make sure your Esteam
®
is unplugged before filling.
2. Check to make sure the factory-installed red o-ring is
secure inside the water tank before operating steamer
(figure #1).
3. Fill with tap or distilled water to the full mark on the outside of the steamer.
Never overfill. Never use water left overnight in steamer. Stale water causes
foaming action and can create water droplets. If you start to see scale
buildup in the water cup of your ESTEAM, it is time to clean it with
our Jiffy Steamer Liquid Cleaner. Not doing so, could alter
the performance of the unit.
4. After filling, place steam cap on steamer and twist
firmly until cap arrows align with arrows on the tank
(figure #2). Make sure it is secure before operating unit.
5. Plug your Esteam
®
into proper voltage outlet. Steamer will start
heating within 15 seconds, providing live steam from cold
water within 2 minutes.
6. Always steam with a vertical up and down motion (figure #3). Do not tilt unit
forward or backward.
7. Avoid allowing steamer to run dry of water.
8. Refer to page 8 for complete cleaning instructions.
WARNING: Never operate without water. Unplug after each use.
Figure 1
Figure 2
5
Features
• 3 times more powerful than any other
hand-held steamer on the market
• Largest water reservoir available
• Wide mouth, easy-to-fill water tank
• 600-watt heating element; automatic safety
shut-off temporarily cuts unit off when
it runs dry
• Uses plain tap or distilled water (no
additives required)
• Comfortable, easy-to-grip handle
• Special outer housing for cool-to-the-
touch operation
• No internal water lines or pumps to
become clogged by hard water
• 9-foot power cord for more manageable
handling
• Fits neatly inside attaché or suitcase
• Available with a multiple plug converter for world travel
Ownerʼs
Manual
Steam Cap
Figure 3
Includes:
ESTEAM
®
Main Body
To Next Page
Loading...
