Jiffy®
J-1/J-2/J-200
Model
Steamer
Directions
1.
For J-2/J-200 models, attach hose firmly with included
assembly wrench, which
is
magnetized and located on
the bottom
of
the unit (figure #1). Assemble and attach
hose hanger rod set. See page 9 for assembly instructions.
For
J-1
models, the brass hat nozzle should already
be
attached. There
is
no rod set for
J-1
models.
2. Invert bottle
of
fresh tap
or
distilled water,
plug
into
proper voltage outlet,
turn
switch to lighted
ON
position
and you will have steam within minutes. Never substitute the
Ji~
Figure
1
Steamer water bottle.
Figure 2
Figure 4
3.
For
easy operation, mount optional
Ji~
Steamboard to
door
or
wall to hold clothing while steaming (figure #2).
For
hanging garments without optional
Ji~
Steamboard, simply install
an
eye screw
or
nail to inside
of
a doorway
or
directly onto a wall
or
you
may use
steamer's rod set as shown
in
figure 3. Touch material
lightly with steaming head and wrinkles will vanish
instantly. The combined touch
of
the steaming head and
the direct steam is very important. Some articles can be
steamed better from the underneath side. Speed and
efficiency is accomplished with a little practice. Always
steam with hose
in
an upright position, so any
condensation is free to flow back into steamer.
If
steaming
in
a low position near floor, extend hose up and
out frequently to keep clear
of
condensation.
DO
NOT
ALLOW
STEAMER
TO
RUN
DRY.
4.
Hang
steam head
in
an
upright
position in the hose hanger section
when
not in use and
turn
switch to
OFF (figure #3).
5.
Periodically, pour old water out
of
steamer to avoid sediment buildup and
maintain proper water level (figure
Figure 3
#4). Remove hard water deposits
with
JiffY
® Liquid
Cleaner. See page 28 for complete cleaning
instructions.
NOTE:
No
two water supplies have the same mineral content.
If
your steamer
begins to cut
on
and
off
during normal use, the thermostat is indicating the
heating unit needs the sediment cleaned out.
To Next Page
Loading...
Need help?
General
