Jiffy
®
J-2000 Directions
1. Attach hose firmly with included assembly wrench,
which is magnetized and located on the bottom of the
unit. Assemble and attach hose hanger rod set.
Every
Jiffy® Steamer has been factory tested and it is not
uncommon for small amounts of water to be in the unit.
2. Invert water caddy filled with distilled or tap water,
plug into proper voltage outlet, turn switch to lighted
ON position and you will have steam within minutes.
Never substitute the Jiffy
®
Steamer water caddy.
3. For easy operation, mount optional Jiffy
®
Steamboard to door or wall to
hold clothing while steaming (figure #2). For hanging garments without
optional Jiffy
®
Steamboard, simply install an eye screw or nail to inside of a
doorway or directly onto a wall or you may use your steamer’s rod set as
shown in figure 3. Touch material lightly with steaming head and wrinkles
will vanish instantly. The combined touch of the
steaming head and the direct steam is very important.
Some articles can be steamed better from the
underneath side. Speed and efficiency is accomplished
with a little practice. Always steam with hose in an
upright position, so any condensation is free to flow
back into steamer. If steaming in a low position near
floor, straighten hose up and out frequently to keep
clear of condensation. DO NOT
ALLOW STEAMER
TO RUN DRY.
4. Hang steam head in an upright position in the hose hanger
section when not in use and turn switch to OFF (figure #3).
5. Periodically, pour old water out of steamer to avoid
sediment buildup and maintain proper water level (figure
#4). Remove hard water deposits with Jiffy
®
Liquid
Cleaner. Wipe water cup out with a hand towel. See page
28 for complete cleaning instructions.
NOTE: No two water supplies have the same mineral content.
If your steamer begins to cut on and off during normal use, the
thermostat is indicating the heating unit needs the sediment
cleaned out.
Figure 1
J-2000
Figure 2
Figure 3
Figure 4
17
WARNING: Never operate without water. Unplug after each use.
To Next Page
Loading...
Need help?
General
